Operating Instructions

Programming
27
Helpline Tel. No.: U.K. 0844 844 3899 R.O.I. 01289 8333
6 M s {ic}
L When the alarm is set, E is displayed.
Note:
L To stop the alarm, press {ic} or place
the handset on the base unit or charger.
L When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Night mode
Night mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each handset.
Important:
L Set the date and time beforehand (page
16).
L We recommend turning the base unit ringer
off (page 25) in addition to turning the night
mode on. (KX-TG6621/KX-TG6622/
KX-TG6623/KX-TG6624)
L If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1 8(238
2 {r}: Select the desired setting. s M
L If you select “Off”, press {ic} to
exit.
3 Enter the desired hour and minute you
wish to start this feature. s M
L You can select 24-hour or 12-hour
clock format (“AM” or “PM”) by
pressing /.
4 Enter the desired hour and minute you
wish to end this feature. s M
5 {ic}
L When the night mode is set, 3 is
displayed.
Changing the start and end time
1 8(237
2 Continue from step 3, “Turning night
mode on/off”, page 27.
Setting the ring delay
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select “No Ringing”,
the handset never rings during night mode.
1 8(239
2 {r}: Select the desired setting. s M
s {ic}
Note:
L When the answering system answers the
call, this feature does not work.
(KX-TG6621/KX-TG6622/KX-TG6623/
KX-TG6624)
Changing the handset name
Each handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 8(1)4
2 Enter the desired name (max. 10
characters; page 39).
L If not required, go to step 3.
3 M
4 {r}: Select the desired setting. s M 2
times
5 {ic}
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred list,
the unit sends out a busy tone to the caller, and
then disconnects the call.
Important:
L When the unit receives a call from a number
that is stored in the call barred list, the call is
TG6611-6621E(e).book Page 27 Monday, November 14, 2011 1:29 PM