Operating Instructions

Base Unit Settings
19
Base unit settings
L Use the handset to customise the base unit.
L When customising the base unit, the current item or setting is indicated by >.
To customise the base unit:
1 {j/OK}
2 Press {^} or {V} to select “Base Unit Setup”. i {>}
3 Press {^} or {V} to select the desired item in the base unit settings menu. i {>}
4 Press {^} or {V} to select the desired item in the sub-menu. i {>}
5 Press {^} or {V} to select the desired setting then press {>} or follow the instruction in the
“Feature” column of the chart.
L To exit the operation, press {ih}.
*1 Change the recall time, if necessary, depending on the requirements of your service
provider/telephone company or PBX.
*2 The default setting will be as follows if you select the following regional codes when
changing the unit’s region setting (page 20):
CZ=100 msec.
SK=100 msec.
*3 If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN
to you. If you forget your PIN, consult your nearest Panasonic service centre.
Base unit settings
menu
Sub-menu Feature (default setting)
Ringer Volume — Base unit ringer volume (Medium)
Call Options Dial Mode (“Tone”): page 11
Recall/Flash Change the recall time
*1
(“600 msec.”
*2
).
Call Restrict page 20
Other Options Base Unit PIN Change base unit PIN (“0000”).
*3
– Enter the current 4-digit base unit PIN.
i Enter the new 4-digit base unit PIN.
i {j/OK}
Repeater Mode (“Off”): page 33
Country Change the unit’s region setting (“EG”):
page 20
TG7100-7120FX(e-e).book Page 19 Thursday, August 10, 2006 10:32 AM