Operating Instructions

Programming
29
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
5 Press the desired category
numbers. i M
L The selected category number
flashes.
L To cancel a selected category
number, press the number again.
The number stops flashing.
6 {ih}
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, see page 47.
1 K (middle soft key) i < i
M
2 {V}/{^}: “Base Unit PIN” i
M
3 Enter the current 4-digit base unit
PIN (default: “0000”).
4 Enter the new 4-digit base unit PIN.
i M i {ih}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 5. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when “Auto” is selected on
base unit (page 30), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a “radio
cell”.
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1 Handset:
K (middle soft key) i N i
M
2 {V}/{^}: “Registration” i M
2 times
3 {V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
4 Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
TG8021E(e).book Page 29 Friday, June 13, 2008 1:19 PM