Operating Instructions

– 5 –
Frequently asked questions
Question Cause/solution
Why is w flashing? LThe handset is too far from the base unit. Move
closer.
LThe base unit’s AC adaptor is not connected.
Check the connections.
LYou are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources
of interference.
LThe handset is not registered to the base unit.
Register it (page 7).
Why is the handset display
blank or goes dark when on
a call?
LThe handset is in screen saver mode. Activate the
handset display again by:
– pressing {<} or {>} when on a call.
– pressing {ih} at all other times.
L“LCD Dimming” is set to “Off” while on charge.
Change the setting.
What should I do when the
handset does not turn on?
LMake sure the batteries are installed correctly.
LFully charge the batteries.
LClean the charge contacts and charge again.
How long is the battery
operating time?
LWhen you are using fully-charged Ni-MH batteries
(supplied batteries);
In continuous use: 14 hours max.
Not in use (standby): 240 hours (10 days) max.
LIt is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
LActual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
Can I keep the handset on
the base unit or charger
when I am not using it?
LEven after the handset is fully charged, the
handset can be left on the base unit or charger
without any ill effect on the batteries.
When should I replace the
batteries?
LIf the batteries are fully charged until 1 is
displayed, but 3 is displayed after a few calls,
replace the batteries with new ones.
What is a PIN? LThe PIN is a 4-digit number that must be entered
in order to change certain base unit settings. The
default PIN is “0000”.
TG8021E(e)_QG.fm Page 5 Thursday, May 29, 2008 3:56 PM