TG8321E(e)_QG.fm Page 1 Tuesday, March 4, 2008 9:52 AM Model No. Quick Guide KX-TG8321E/KX-TG8322E KX-TG8323E/KX-TG8324E Connections Base unit Hook “Click” Use only the supplied telephone line cord. To telephone line “Click” DSL/ADSL filter (For DSL/ADSL service users) Hook Press plug firmly. (220-240 V AC, 50 Hz) Use only the supplied Panasonic AC adaptor PQLV207E. Important: L If you use a telephone line cord which is not supplied, the unit may not work properly.
TG8321E(e)_QG.fm Page 2 Tuesday, March 4, 2008 9:52 AM Battery installation/Battery charge Charge for about 7 hours. Base unit Rechargeable Ni-MH ONLY Charger *1 “Charging” will be displayed. *1 KX-TG8322/KX-TG8323/KX-TG8324 Note: L USE ONLY Ni-MH batteries AAA (R03) size. L Do NOT use Alkaline/Manganese/Ni-Cd batteries. Screen saver mode The backlight goes dark when on a call or turns off completely after 1 minute of inactivity if the handset is not on the base unit or charger.
TG8321E(e)_QG.fm Page 3 Tuesday, March 4, 2008 9:52 AM Operating tips Using the joystick Volume up The handset joystick can be used to navigate through menus and to select items shown on the display by pushing it up {^}, down {V}, left {<}, or right {>}. To adjust the receiver or speaker volume, push the joystick up to increase the volume, or down to decrease the volume repeatedly while talking. Volume down Soft keys The handset features 2 soft keys and a joystick.
TG8321E(e)_QG.fm Page 4 Tuesday, March 4, 2008 9:52 AM Basic operations Making/Answering calls (Handset) Making calls Dial the phone number. i {C}/{s} Answering calls {C}/{s} To hang up {ih} To adjust the receiver/ speaker volume Push the joystick up or down repeatedly while talking. Making a call using the redial list j (right soft key) i {V}/{^}: Select the desired phone number.
TG8321E(e)_QG.fm Page 5 Tuesday, March 4, 2008 9:52 AM Frequently asked questions Question Cause/solution Why is w flashing? L The handset is too far from the base unit. Move closer. L The base unit’s AC adaptor is not connected. Check the connections. L You are using the handset or base unit in an area with high electrical interference. Place the base unit and use the handset away from sources of interference. L The handset is not registered to the base unit. Register it (page 7).
TG8321E(e)_QG.fm Page 6 Tuesday, March 4, 2008 9:52 AM Frequently asked questions Question Cause/solution What should I do to display caller information? L You must subscribe to a Caller ID service. Contact your service provider/telephone company for details. L The message “You must first subscribe to Caller ID.” will be displayed until you receive caller information after subscribing to a Caller ID service.
TG8321E(e)_QG.fm Page 7 Tuesday, March 4, 2008 9:52 AM Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit, register the handset. Handset 1 K (centre of joystick) i N i M 2 {V}/{^}: “Registration” i M 2 times 3 {V}/{^}: Select a base unit number. i M M Base unit Press and hold {x} for about 5 seconds, until the registration tone sounds. L The next step should be completed within 90 seconds.
TG8321E(e)_QG.fm Page 8 Tuesday, March 4, 2008 9:52 AM Optional services (Caller ID and SMS) If you subscribe to a Caller ID service, you can: – display caller information 012345 – identify who is calling by using different display colours and ringer tones (phonebook category) 012345 To use SMS, you must subscribe to a Caller ID and/or an appropriate service.
TG8321E(e)_QG.
TG8321E(e)_QG.fm Page 10 Tuesday, March 4, 2008 9:52 AM IMPORTANT If you have any problems operating this product, please try the following: 1 Reconnect AC adaptor. 2 Use supplied telephone line cord. 3 Use rechargeable Ni-MH batteries. (Alkaline batteries CANNOT be used.) Refer to Troubleshooting in Operating Instructions and FAQs in this Quick Guide.