Operating Instructions

Blocking incoming calls that
have no phone number
You can reject calls when no phone number is
provided, such as private callers.
1 M
N#240
2 MbN:
Select the desired setting. a MOKN
3 M
N
Viewing/editing/erasing call
block numbers
1 M N#217
2 MbN:
“Single Number” or “Range of
Numbers” a MOKN
3 MbN: Select the desired entry.
R To exit, press M
N.
4 T
o edit a number:
M
N a
Edit the number. a MOKN a
M
N
T
o erase a number:
M
N a MbN:
“Yes” a MOKN a M
N
N
ote:
R When editing, press the desired dial key to
add, MCN to erase.
Erasing all call block numbers
1 M N#217
2 MbN:
“Single Number” or “Range of
Numbers” a MOKN
3 M
N a MbN:
“Erase All” a MOKN
4 MbN: “Yes” a MOKN
5 MbN: “Yes” a MOKN a M
N
Other programming
Changing the handset name
E
ach handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
t
he handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” or “Handset 2” is displayed.
1 M
N#104
2 E
nter the desired name (10 characters
max.).
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times a M
N
Call restriction
Y
ou can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1 M
N#256
2 E
nter the base unit PIN (default: “0000”).
R If you forget your PIN, contact an
authorised service centre.
3 Select the handsets to be restricted by
pressing 1 to 2.
R All handsets registered to the base unit
are displayed.
R “
” is displayed next to the selected
h
andset numbers.
R To cancel a selected handset, press
the same dial key again. “
”
d
isappears.
4 MOKN
5 Select a memory location by pressing 1
to 6. a MOKN
6 Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M
N
Changing the base unit PIN
I
mportant:
R If you change the PIN (Personal
Identification Number), please make note of
24
Programming
TGC210_212FX_(en-en)_0410_ver.031.pdf 24 2014/04/10 16:35:46