Operating Instructions

your new PIN. The unit will not reveal the
P
IN to you. If you forget your PIN, contact
an authorised service centre.
1 M
N#132
2 Enter the current 4-digit base unit PIN
(default: “0000”).
3 Enter the new 4-digit base unit PIN. a
MOKN
4 MbN: “Yes” a MOKN a M N
Changing the unit’s region
setting/Resetting the base unit
1 M N#136
2 MbN:
Select the desired country. a MOKN
“Other” = Countries except Czech and
Slovakia
“Česká rep.” = Czech
“Slovensko” = Slovakia
3 MbN: “Yes” a MOKN a M
N
N
ote:
R Changing the unit’s region setting may
cause the settings for your country or your
customised settings to return to their default
settings.
Increasing the range of the base
u
nit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 3. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1 M
N#138
2 MbN:
Select the desired setting. a MOKN
a M
N
Registering the DECT repeater
(
KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Press and hold M
N
for about 5 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and indicator light
g
reen.
3 Base unit:
To exit the registration mode, press M
N.
25
Programming
TGC210_212FX_(en-en)_0410_ver.031.pdf 25 2014/04/10 16:35:47