Operating Instructions

Sub-menu 1 Sub-menu 2 Settings Code
Ringtone
*
5
(Handset)
– <R
ingtone 1> #161 –
Do Not Disturb
M
ode
On/Off On
<Off>
#238 30
Start/End
<23:00/06:00> #237 30
Ring Delay 30 sec.
<6
0 sec.>
90 sec.
120 sec.
No Ringing
#239 30
Select Category Category 1-9
#241 30
First Ring
*
2, *6
– <O
n>
Off
#173 –
Main menu: “Nuisance Call Block”
*2, *16
Sub-menu 1 Sub-menu 2 Settings Code
Single Number
– – #217 30
Range of Numbers
– –
Withheld
–
On
<O
ff>
#240 31
*1 KX-TGD320 series: page 3
*
2 If you program these settings using one of the handsets, you do not need to program the
same item using another handset.
*3 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*4 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select “Caller ID”. To turn this feature off, select “Manual”.
(Caller ID subscribers only)
To use this feature, set the date and time first (page 15).
*5 The preset melodies in this product are used with the following permission:
– “Ringtone 3”: © 2014 Copyrights Vision Inc.
– “Ringtone 4” - “Ringtone 40”: © 2012 Copyrights Vision Inc.
*6 If you do not want the unit to ring before the caller information is received, set to “Off”.
(Caller ID subscribers only)
You can only remove the first ring if the unit rings 2 times or more by default, which depends
on your phone service provider.
*7 This setting is available when you have the key finder (KX-TGA20EX). Read the installation
manual for more information on the key finder.
*8 For models with supplied key finders, the display shows “1:Finder1”.
*9 If you register 2 or more key finders.
*10 This menu is not displayed when repeater mode is set to “On”.
*11 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
28
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Programming
TGD31x_32xE(en)0202_ver201.pdf 28 2015/02/02 14:00:40