Operating Instructions
Key Operation
76 Record greeting message
8 Turn answering system on
MPAUSEN
Pause message
*2
9 or
MSTOPN
Stop recording
Stop playback
0 Turn answering system off
*4
*3
Erase currently playing message
*5 Erase all messages
*6 Reset to a pre-recorded greeting
message
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
*2 To resume playback:
MbN: “Playback” a MSELECTN
*3 You can also erase as follows:
MPAUSEN a MbN: “Erase” a MSELECTN
a MbN: “Yes” a MSELECTN
Calling back (Caller ID subscribers only)
n Using a landline:
1 Press MPAUSEN during playback.
2 MbN: “Call back” a MSELECTN
n Using a cellular line:
1 Press MPAUSEN during playback.
2 MbN: “Call back (Cell)” a MSELECTN
R The unit starts dialing immediately in the
following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 20).
3 MbN: Select the desired cellular phone. a
MSELECTN
Editing the number before calling back
n Using a landline:
1 Press MPAUSEN during playback.
2 MbN: “Edit & Call” a MSELECTN
3 Press MEDITN repeatedly until the phone
number is shown in the desired format
(page 58).
4 M N
n Using a cellular line:
1 Press MPAUSEN during playback.
2 MbN: “Edit & Call” a MSELECTN
3 Press MEDITN repeatedly until the phone
number is shown in the desired format
(page 58).
4 MCELLN
R The unit starts dialing immediately in the
following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 20).
5 MbN: Select the desired cellular phone. a
MSELECTN
Erasing all messages
1 MMENUN#325
2 MbN: “Yes” a MSELECTN a MOFFN
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to inform
you of a new message arrival when new
messages are recorded. The base unit beeps 2
times every minute until you listen to the
messages, if the “Base unit beep” setting is
turned on. The default setting is “Off”.
Handset / Base unit
1 MMENUN#339
2 MbN: Select the desired setting. a MSAVEN
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
New message alert by a call
This feature allows you to receive a notification by
phone when new messages are recorded. The
base unit calls a phone number you specify. You
can then operate the answering system remotely
to listen to the new message.
To use this feature, you must:
– store a phone number to which the unit makes
the call to.
– turn on the new message alert setting.
68
For assistance, please visit http://shop.panasonic.com/support
Answering System for Landline