Operating Instructions

R T
he following are used for both uppercase and lowercase:
Cyrillic character table ( )
z
y
1
2 3 4 5 6 7 8 9
Error messages
Display message Cause/solution
Base no power
o
r
No link to base.
Reconnect main
base AC adaptor.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been cancelled.
Re-register the handset (page 68).
Check
P
hone Line
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 11).
R If you do not connect the telephone line cord and use only
mobile lines, set the mobile line only mode (page 20).
Error
R R
ecording was too short. Try again.
R Someone is using a mobile line or headset. Try again later.
R The phonebook copy is incomplete (page 48). The mobile
phone is disconnected from the base unit. Make sure that
other Bluetooth devices are not connected to the mobile
phone, and try again.
Failed
R A
lthough the unit tried to connect to the mobile phone or
headset, the connection has been failed.
– Someone is using a mobile line or headset. Try again later.
– Make sure that the mobile phone or headset is not
connected to other Bluetooth devices.
Memory Full
R T
he phonebook memory is full. Erase unwanted entries
(page 29).
R Message memory is full. Erase unwanted messages
(page 53, 54).
R The call block list memory is full. Erase unwanted entries
(page 42).
Use
r
echargeable
battery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 8.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
61
Useful Information
TGH26xE_(en)_0203_ver120.pdf 61 2017/02/03 14:07:10