Operating instructions

Problem Cause/solution
I cannot use the intercom
feature.
R This feature is available between the handsets. Although the
handset displays “Intercom”, or “Auto Intercom”, these
features are not available for single handset models.
The unit does not emit the
specified number of rings.
R The number of rings decreases by 1 from the specified
number of rings in below situations:
– the first ring is turned off (“Off”) (page 30)
– automated call block is set to “Block” (page 21)
Menu list
Problem Cause/solution
The display is in a
language I cannot read.
R Change the display language (page 14).
I cannot activate the eco
mode.
R You cannot set eco mode when you set the repeater mode
“On”. If required, set the repeater mode to “Off” (page 38).
I cannot register a handset
to a base unit.
R The maximum number of base units (4) is already registered to
the handset. Cancel unused base unit registrations from the
handset (page 38).
R You entered the wrong PIN. If you forget your PIN, see “I
cannot remember the PIN.” (page 52).
I cannot remember the
PIN.
R Change the PIN using the following method.
1 MMENUN (right soft key) #132
2 *7000
3 Enter the new 4-digit base unit PIN. a MOKN
4 MbN: “Yes” a MOKN a M
N
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R Battery charge is low. Fully charge the batteries (page 11).
I fully charged the
batteries, but
– still flashes or
– the operating time
seems to be shorter.
R Clean the battery ends ( , ) and the charge contacts with
a dry cloth and charge again.
R It is time to replace the batteries (page 10).
52
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Useful Information