Operation Manual

Recording
- 90 -
∫ Displaying the MF Assist
•
It is displayed by rotating the focus ring or touching the screen.
• It can also be displayed by pressing 2 to display the setup screen for the enlarged area,
deciding the area to enlarge using the cursor button, and then pressing [MENU/SET].
• It will switch to the setting screen for the enlarged area by pressing the cursor button when the
[DIRECT FOCUS AREA] in the [CUSTOM] menu is set to [ON].
∫ Changing the display of the MF Assist
You can modify it to display (4k) MF Assist on the centre of the screen or in full screen
(5k/10k). After making changes, the MF Assist that was previously used will be
displayed.
•
MF Assist display can be changed by touching [ ]. It will return to previous by touching [ ].
• Changes can also be performed by rotating the rear dial.
∫ Moving the enlarged area
•
The enlarged area can be moved by dragging the screen (P12), or pressing the cursor button.
• The following will return the MF assistance to the original position.
– When the [FOCUS MODE] is set to other than [MF]
– Changing [ASPECT RATIO] or [PICTURE SIZE]
– Turning the camera off
– When [ ] is pressed in the setup screen for the enlarged area
∫ Closing the MF Assist
•
It will close when the shutter button is pressed halfway.
• It will also close by touching the [EXIT] on the screen or pressing [MENU/SET].
• When displayed by rotating the focus ring, it is closed approximately 10 seconds after the
operation is stopped.
Note
•
The MF Assist is disabled when using the Digital Zoom or recording motion pictures.
• MF Assist or MF guide may not display depending on the lens used, but you can display MF
Assist by direct operation of the camera, using the touch panel or a button.
MF ASSIST