Two-Way Radio User Manual

2-52
7KLVVHUYRGULYHUIHDWXUHVNLQGVRIFRPPXQLFDWLRQIXQFWLRQ56DQG56DQG\RXFDQXVHLQ
3 connecting methods.
To communicate with a single driver through RS232
Connect the host (PC or controller) to an driver through RS232.
[How to connect]
To communicate with multiple drivers through RS232 and RS485
By connecting the host (PC and host controller) and one driver via RS232 and connect-
ing other drivers via RS485 each other, you can connect multiple drivers.
Note
<RXFDQFRQQHFWXSWRGULYHUVZLWKWKHKRVW
)RUGHWDLOVUHIHUWR3&RPPXQLFDWLRQRI6XSSOHPHQW
To communicate with multiple drivers only through RS485
Communications between the host (PC or controller) and multiple drivers can be made
through RS485.
Note
<RXFDQFRQQHFWXSWRGULYHUVZLWKWKHKRVW
)RUGHWDLOVUHIHUWR3&RPPXQLFDWLRQRI6XSSOHPHQW
Connector X2
Connector
Shut off both powers of
the PC andthe driver
before inserting/pulling
out the connector.
Cable prepared
by the user
RS485RS485
RS232
Host controller
(PC controller)
Connector X2 Connector X2 Connector X2
Set the axis number (Pr5.31) of driver
to be connected through RS485 to a value
in the range 1 to 31.
Set the axis number (Pr5.31) of driver to be
connected to the host through RS232 to 0.
4. Wiring to the connector, X2
Connecting host computer
RS485RS485
RS232
Host controller
(PC controller)
Connector X2 Connector X2 Connector X2
Set the axis number (Pr5.31) of driver to be connected
through RS485 to a value in the range 1 to 31.
Remarks
Note
;WR;DUHXVHGIRUWKHVHFRQGDU\FLUFXLW7RFRQQHFWWKHVHWHUPLQDOVWRWKHSULPDU\SRZHU
supply (particularly, the 24 VDC power supply for control, the 24 VDC power supply for brake,
and the 24 VDC power supply for regenerative resistor [H-frame only]), insulation is required.
Do not connect these terminals to the same power supply.
2QO\IRUSRVLWLRQFRQWUROW\SHLVQRWSURYLGHGZLWK;