Operating instructions

38
Moving and Installing
The anchor rods keep the interior of
the appliance in place, and protect it
from vibration during transportation.
NOTE
● Operating the appliance with anchor
rods still attached will cause
excessive vibration. They must be
removed before operation.
● Store the anchor rods and brackets.
They will be needed when the
appliance is moved again in the
future.
● When moving the appliance again,
the anchor rods and brackets must
be attached to the appliance. Attach
the anchor rods in the reverse order
they were removed. If having
difficulty on positioning the anchor
rods, try the following:
- Insert the anchor rod while turning
it.
- Insert and position two anchor
rods in parallel at the same time.
- Insert the anchor rod while moving
the drum a little.
■How to remove
1 Remove two screws.
2 Remove the bracket.
3 Set the bracket to the groove of the
anchor rod, and turn 90 degrees.
Removing the anchor rods
Anchor rods
Drum
Anchor rods (2)
(Rear of appliance)
39
7
Installation
Service person only
4 Pull the anchor rod out.
The rod stops twice during removal.
Pull the rod while turning it.
5 Attach the cover cap to the hole. If
the caps are not attached, foreign
objects may enter the appliance and
cause a malfunction.
Prepare a No.17 spanner. (sold
separately)
1 Loosen the lock nut with the
spanner.
2 Turn the adjustable foot to adjust
the height.
3 Tighten the lock nut. (A spirit level is
useful for making sure the appliance
is level.)
NOTE
● Make sure that all lock nuts are
tightened securely and the
adjustable feet are still bolted to the
appliance.
If they are unbolted, the appliance
will shake and move around.
Levelling the appliance
4 adjustable feet
(4)
(3)(2)(1)
Lock nut
Adjustable feet
1
2
3