Operating instructions

42
Checking after Installation
Appliance parts checklist
Is the appliance level? (P.39)
Have you removed all 2 anchor
rods and fitted cover caps?
(P.38, 39)
Is the appliance plugged into an
AC 220-240 V household mains
socket? (see back cover)
Are they stable and securely
tightened? (P.39)
Is the water supply hose
properly connected? Is it free
from leaks? (P.41)
Is the appliance on a flat, stable
surface?
Does it run without vibrating?
(P.39)
Is the drain hose properly
connected? Does it drain
normally? (P.41)
Anchor rods
Mains plug
Adjustable feet Water supply hose
Installation place Drain hose
Water supply hose
Mains plug
Adjustable feet (4)
Do not remove the fastener of the drain hose
in the upper left.
Drain hose
Anchor rods (2)
43
7
Installation
Service person only
Test run
6 3, 7745 10 8 9
1
Turn on the tap.
2
Close the door without any
laundry in the drum.
3
Switch on the appliance.
4
Select the “Quick 50”
programme.
5
Select M.
6
Start operation.
7
Switch the appliance off
and on.
8
Select .
9
Press for about 5
seconds.
is displayed.
10
Press while is
displayed to start test
run.
is displayed.
Operation finishes after about
3 minutes.
Check the appliance and hose
joints for leaks. (P.40)
Water leaks
Make sure the appliance is
level. (P.39)
Abnormal noise
Unable to supply water
(P.36)
After resolving an error, open
and close the door and press
“Start/Pause” to resume the test.
Error display
Unable to drain (P.36)