Operating instructions

40 - Installation Instructions
Moving and Installing
Removing the anchor bolts
Four anchor bolts keep the interior of the
appliance in place while the appliance
is being moved. Remove them before
installation, using a spanner. Follow the
instructions below.
Note
The anchor bolts must be removed
before the appliance is operated.
They may cause excessive vibration.
Use a spanner to loosen the four 1.
bolts.
Rotate the bolts anti-clockwise.
Pull the bolts out horizontally.2.
Attach each cover cap (included with 3.
the accessories) over each bolt hole.
Note
Make sure that you store the anchor -
bolts because they are used when
transporting the appliance. If the
appliance is passed on to another
person, make sure to give the
anchor bolts to that person.
Make sure the cover caps are -
attached. Failure to observe this
may result in water entering the
washing machine, leading to
malfunctions.
Moving the appliance
Note
Make sure to install the anchor bolts in
the appliance.
Before you move the appliance
Shut the tap and run the appliance to -
drain the water. Drain remaining water
from the drain filter. (P.31)
Depressurize and remove the water -
supply hose.
Disconnect the power cable. -
Install the anchor bolts. (P.41) -
NA-148VB6_English_UK.indb 40 2016-6-13 10:51:25