Operating Instructions

ManualsBrandsPanasonic ManualsHome AppliancesNE1643EUG

- 29 -

English

Installation Instructions for Stacking

This oven monitors its operation and displays a Failure Code in the Digital Display Window when a problem occurs.

What to do when a failure code appears:

Unplug the oven and wait more than 10 seconds before reconnecting.

If normal operation does not resume, follow next chart.

CODE PROBLEM WHAT TO DO (BELOW)

F01 Temperature of exhaust air too High 1./2./3./4./5.

F33 Defective Thermistor Circuit 1./5.

F44 Defective Control Panel 1./5.

F81–82 Defective Relay Circuit 5./6./7.

F86–87 Defective Relay Circuit 1./5.

U30 Memory cooking has exceeded the maximum time during

double quantity and triple quantity setting.

Check and change the time.

— See page 15, step 3 “Note”.

1. Oven shuts off automatically. Disconnect the power cord from the wall socket.

2. Oven beeps continuously.

3. Oven resets for operation when cool.

4. Move oven to cooler location.

5. If problem persists call service agent.

6. Oven will operate even if failure code appears, just not as designed. Call service agent.

7. Press Stop/Reset Pad and try again.

Note: Above Codes shown in the display do not indicate all the possible failures on the unit.

Important

1. Disconnect the power cord from the wall socket

before attempting installation.

2. For stacking installation, you must use the

Panasonic Joint Plate A1134-3280 (Available via

service route).

3. Combination of the unit for stacking is limited within

only the following models.

NE-2153-2, NE-1653, NE-2143-2, NE-1843,

NE-1643

4. Do not stack more than one oven above bottom

oven.

Preparation

Be sure the oven cavity is empty.

Installation

1. Stack the units and remove ﬁve screws a as shown

in Fig. 1.

2. Loosen the screw b.

3. The projection on the Joint Plate must face away

from the oven. Place the Joint Plate on the screw

4. Attach and tighten ﬁve screws a and the screw b.

See Fig. 2.

5. Ensure the top oven is at a safe and workable

height.





Joint Plate

Joint

Plate

Projection

Fig. 1 Fig. 2

Self Diagnostics Failure Code Explanation