Operation Manual

13
VQT9002
Functions of the NV-FJ614 Series (Hi-Fi)
Timer Recording with ShowView
Switch on the TV to the video output channel, insert a cassette with an
intact erasure prevention tab into the VCR and set the
remote control to VCR operation .
Press this button.
Enter the ShowView number.
For correction use .
To access [Timer recording], press .
Select your Channel [Pos] and
store with (only necessary the
first Timer recording for each Channel).
The [Name] of the Channel you can set
manually (see page 9).
Set the Tape Speed SP, LP,
EP (SUPER LP) or A (automatic).
In the setting A the VCR switches automatically
(with a short picture distortion) to the slow tape speed LP,
to record the programme so long as possible.
To store the programme, press .
In order to preset other recordings repeat this procedure.
To check the Remaining tape time,
look to the VCR display Remain.
Make sure that the remaining time
on the cassette is longer than the
time set for recording, otherwise the
whole programmes cannot be recorded.
Switch the VCR to Standby mode for
Timer recording. Make sure that the
VCR display appears.
Notes:
You can use the cursors on the remote control to move around
the menu , in order to make changes .
SHOWVIEW is a trademark of Gemstar Development
Corporation. The SHOWVIEW system is manufactured
under licence from Gemstar Development Corporation.
Pos Start Stop
Name DATE ON OFF
1. - - - - - - - 13:30 14:00 SP
Panasonic VCR
Timer recording 1/2
8 3 5 4 2 - - - -
Panasonic VCR
Show View
Pos Start Stop
Name DATE ON OFF
1. 1
***
01 13:30 14:00 SP
Panasonic VCR
Timer recording 1/2
Pos Start Stop
Name DATE ON OFF
1.
***
01 8/12 13:30 14:00 SP
2.- - - - - - -/- - - -:- - - -:- - -
Panasonic VCR
Timer recording 1/2