Instruction manual (EB_EBL) ENG

29
Creating a new station table
!
Press MENU, the Menu screen appears.
!
With select the Tuning menu, confirm with ENTER.
!
With select [Auto Setup], confirm with ENTER.
!
Press ENTER to confirm.
Shipping condition/factory defaults
Shipping condition resets the VCR back to the original factory settings except
Owner ID information. This is useful if the VCR is going to be used in a new
location as auto-setup will begin again when the unit is switched on (after
connecting to aerial and mains).
!
Press MENU, the Menu screen appears.
!
With select the Tuning menu, confirm with ENTER.
!
With select [Shipping condition] and confirm with ENTER.
!
Press ENTER to confirm.
!
To re-tune the VCR, disconnect and reconnect the AC Mains lead.
The Auto Setup menu will be displayed.
The Automatic Tuning will start.
D
When no stations have been set, confirm all connections and restart Auto Setup.
D
You can restart Auto Setup, without using remote controller, by pressing some
buttons on the front of the unit. Hold down and on the main unit
simultaneously for about 5 seconds.
Tuning
Manual
Auto Setup
Shipping condition
Owner ID
: yes : no
ENTER
EXIT
OK?
Auto Setup
Tuning : Ch 1
Tuning
Manual
Auto Setup
Shipping condition
Owner ID
: yes : no
ENTER
EXIT
OK?
Manual Functions