Instruction manual (EB_EBL) ENG

32
To manually adjust the clock
The clock will normally be set correctly during Auto-Setup however, in some
circumstances the VCR cannot set the clock automatically. In this case, follow the
operation steps below to manually set the clock.
!
Press MENU and select Clock set .
!
Press ENTER.
!
Confirm that Clock set is set to MANUAL, and press ENTER.
!
Use or Numeric buttons to set the Date and Time.
!
Press ENTER to conclude the settings.
!
Press EXIT to exit the On Screen Display.
To activate the automatic time correction function
The correct time for the VCR clock can be automatically maintained when the VCR
is tuned to a station that transmits a time signal.
D
If Clock setting is set to AUTO when you open the Clock screen, do not set it to
MANUAL, otherwise, the automatic time correction function is deactivated.
D
This VCR uses a 24 hour clock.
D
In case of a power failure, an automatic back-up system maintains the clock for
approximate 60 minutes.
D
When Clock setting is set to AUTO, the automatic time correction function checks
and if necessary adjusts the time several times every day. The automatic time
correction function only works when the VCR is in standby, it does not work in the timer
recording mode.
D
Don't forget to change summer time and winter time
!
Press MENU and select Clock set .
!
Press ENTER.
!
Use to set AUTO.
!
Press ENTER to conclude the setting.
!
Under adverse reception conditions, etc., the Automatic time correction function
may not work. In this case, the indication for Clock setting is automatically reset
to MANUAL. If the reception conditions improve later on, it is possible to activate
this function.
!
Press EXIT to exit the On Screen Display.
Clock setting
Menu
Timer recording
Tuning
Clock set
Others
:select : access
: exit
ENTER
EXIT
Datum / ZeitClock set
Time : 12 : 00 : 00
Date : 11. 6. 04
MANUAL
Datum / ZeitClock set
Time : 12 : 00 : 00
Date : 11. 6. 04
AUTO
Manual Functions