Instruction manual (EG) ENG

SV121 HV61 MV21 HV51 MV16

SV121 HV61 HV51 MV21 MV16

Checking the timer programme

Press PROG/CHECK,

the Timer recording menu appears.

Press PROG/CHECK again or EXIT

to quit the menu.

Playing back programmed recordings

Press PROG PLAY.

The device will rewind to the beginning of the recording,

and automatically start playing it back.

Automatic SP/LP selection

A: If, at the beginning of a timer programme, there is not

enough tape left to complete it, the SP/LP function will

automatically run the tape at LP speed. This ensures that the

entire programme will be recorded. If the LP mode is not

enough to ‘stretch’ the remaining tape to fit, you will not be

able to record all of the TV programmes.

It is not possible to automatically activate the EP mode.

VPS/PDC function

If a TV programme begins or ends earlier or later than planned,

this function synchronises the beginning and end of the

recording session with the actual beginning and end of the TV

programme through a VPS signal transmitted by the TV station.

ON : The station transmits VPS/PDC signals. You must set the

timer to the time specified in the TV magazines. Use the

special VPS time the TV magazine may indicate.

- - - : The station does not transmit VPS/PDC signals. Try to set

the start and stop time such that the entire film can be

recorded even if a programme begins or ends earlier or

later than planned.

Changing or cancelling a timer programme

Press PROG/CHECK,

the Timer recording menu appears.

! With select the entry you would like to edit,

confirm with ENTER.

Modify entries with and confirm with ENTER.

Press RESET/CANCEL to delete a recording.

Timer recording