Instruction manual (EG) ENG

4
TV
AC mains lead
SV121 HV61 HV51 MV21 MV16
SV121 HV61 MV21 HV51 MV16
SV121 HV61 MV21 HV51 MV16
VCR
1
2
3
4
4
3
2
1
Antenna
AC IN
RF IN
Antenna input
AV1
21-pin Scart socket
RF OUT
Antenna output
AC mains lead
Antenna input
RF coaxial cable
21-pin
Scart cable
AC IN~
8
VCR Auto Setup with 21-pin Scart cable
Connecting with a 21-pin Scart cable
Follow the steps
described below.
Disconnect power to
all devices.
Connect antenna to the
RF IN (Antenna input)
connector of the VCR.
Connect the VCR’s RF OUT
(Antenna output) to the
television set’s antenna input
connector.
Connect the VCR’s AV1 socket
(21-pin Scart socket) to the TV
set’s Scart In socket.
Connect VCR and TV set to
the AC mains supply.
!
Turn on your television set.
!
With the Stand-by/on switch turn on the VCR.
The Country menu appears.
!
With the arrow buttons select the according country, and
confirm by pressing ENTER.
Automatic tuning for all receivable TV stations begins.
Approximate duration is 5 minutes.
If menu Clock set appears
If time and date are not transmitted by a TV station, they must be set
manually.
!
Enter Time and Date with or ... , then
save with ENTER.
1 2 3
0
After running the automatic tuning Time and Date must be set manually.
!
Enter Time and Date with or ... , then
save with ENTER.
1 2 3
0
D
Mind that a wrong date or time will influence the programmed
recording of TV programmes (don't forget to change summer time
and winter time).
D
If the Country menu does not
appear after turning the device
on, you may reset the device to
its factory defaults (page 17).
Upon doing so the VCR Auto
Setup will start again.
(Automatic tuning)
AC mains lead