Operating Instructions - Language - English

Please contact our after sales service centre if you fail to remove problems by yourself (see Guarantee Information).

Check AC mains connection.

Check Power save

The recording functions do not work properly:

If flashes on the device, check if the protection tab of the video

cassette is still in.

Check Time and Date

Check the start and stop time of the timer programme.

Check if the TIMER button has been pressed to put the device

into timer mode after programming a recording.

Check the start and stop time of a VPS/PDC recording.

Remote control unit functions don’t work:

Check distance to the device (max. 7 metres).

Check remote control unit’s batteries

Bad picture or sound:

Fast winding forward and backwards causes motor noises.

These are not malfunctions.

Device is set to recording stand-by or timer mode.

Quit with EXT LINK button or TIMER button.

The VCR display is not lit:

The VCR display is lit, the device does not respond to controls:

Raised motor noise level:

Automatic Clock set doesn’t work properly:

The use of E-300 cassettes may cause problems if the recordings

were taken at low tape speeds (LP or EP)

Check [PAL] and [MESECAM] settings.

Verify that the aerial and/or Scart cables are attached and work

properly.

Check the SQPB/ S-VHS playback setting for S-VHS cassettes.

Faulty recordings taken at slow tape speed (EP) in [MESECAM]

are not malfunctions.

Please contact your service technician if the video heads are dirty

or worn out.

Having a technical service shop clean the video heads is not

covered by the guarantee.

Set Clock set to [AUTO]

If the device cannot find a TV station transmitting the time signal,

set Time and Date manually.

Before requesting service