Operating Instructions

Recording with ShowView
(not for VP23)
ShowView
23
ShowView
is a trademark of Gemstar Development
Corporation. The ShowView system is
manufactured under licence from
Gemstar Development Corporation.
ShowView
: enter : access
0 - 9
: correct : exit
ENTERENTERENTERENTERENTERENTERENTERENTER
EXITEXITEXITEXITEXITEXITEXITEXIT
8 3 5 4 2 - - - -
Timer recording 1/3
: select access
:
: delete : exit
ENTERENTERENTERENTERENTERENTERENTERENTER
CANCELCANCELCANCELCANCELCANCELCANCELCANCELCANCEL
EXITEXITEXITEXITEXITEXITEXITEXIT
Pos Date Start Stop
VPS
PDC
1 ARD 31/12 10:30 11:30 SP ON
1 ARD 31/12 11:30 12:30 SP ON
2 ZDF 31/12 12:30 13:30 SP OFF
- - - - - - - -/ - - - -:- - - -:- - - - - -
- - - - - - - -/ - - - -:- - - -:- - - - - -
- - - - - - - -/ - - - -:- - - -:- - - - - -
Programming recordings with the ShowView function
The ShowView code simplifies entering programme information to record
TV and SAT programmes.
!
Press ShowView.
!
Enter the ShowView number ( to correct entry).
!
Confirm entry with ENTER.
The Timer recording screen appears.
If the device fails to recognise the TV station automatically, it must be entered
manually with . The VCR will store this information so it will not have to be entered
again.
Modifying programmed data
!
Press PROG/CHECK.
The Timer recording menu appears.
!
With select the entry to be modified, confirm with ENTER.
!
Select station and use to set date, week or weekday , .
!
Then enter start and stop time , .
!
Select tape speed: A (Automatic), SP, LP, EP , and
confirm with ENTER.
!
Press TIMER to activate the VCR’s timer mode.
PROG/CHECK
Activating timer mode
!
Press TIMER to activate the timer mode.
The symbol appears on the VCR display. The Timer Rec button on the device
also lights up if the function was not turned off.
D
The Timer Rec button blinks for 5 seconds if the timer is turned on and you try to
perform a function. Most buttons are blocked when the timer is turned on.