Instruction Manual (EG) EN

The model no. and serial no. of this product are stuck down on the rear of the appliance.
Please enter them below to serve as reference.
Model No.
Serial No.
45
VCR DISTORTIONS
Before requesting service
Manual correction of a bad picture:
!
If you notice interference or a shift of the picture during normal, still or slow motion playback, press the
utton towards + or - to correct the picture.
!
Press + and - together to actuate automatic correction. Some video cassettes do not support tracking
control. This is not indicative of a malfunction.
TRACKING / V-LOCK b
The automatic clock does not
set correctly:
!
Set
!
Clock set to AUTO (page 22).
Set Time and Date manually if the unit does not find a station emitting the time signal.
Bad picture or sound:
!
The use of E-300 cassettes may cause problems if the recordings were taken at slow tape speeds
(LP or EP).
Check the settings for PAL, MESECAM (page 21).
Verify that the aerial and/or scart cables are attached and work properly.
Check the SQPB setting for S-VHS cassettes (page 21).
Faulty recordings taken at slow tape speed (EP) in MESECAM are not indicative of a malfunction.
Please contact your service technician if the video heads are dirty or worn out.
Having a technical service shop clean the video heads is not covered by the guarantee
!
!
!
!
!
.
The recording functions do not
work properly:
!
If flashes on the unit,
check if the protection tab of the video cassette is still in.
!
Check the menu (page 22).
!
Check the start and stop time of the timer programme (page 12).
!
Check if the button has been pressed to put the unit into timer mode after programming a
recording (page 12).
!
Check the start and stop time of a recording (page 13).
Clock set
TIMER
VPS/PDC