Operation Manual

20
- ENGLISH
Preparation
Using Remote control
Installing and Removing batteries
Open the cover1 ) Install batteries and close the cover2 )
(Insert the – side rst.)
Remove the batteries in the reverse order of installation.
z
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate each projector individually using single
remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 2 different ID codes (Code 1 and Code 2), the initial ID number is [Code 1].
J
Setting the ID number
Press and hold both the MENU and IMAGE buttons together for 5 seconds or more. After changing the
code, make sure the remote control operates properly.
Note
For details, please refer to the [Remote control] of the [Setting] menu. (
z
Æ
page 57)
This remote control is only for PT-CW230EA and PT-CX200EA. You cannot operate the other Panasonic projectors by
z
using this remote control.
MENU button
IMAGE button