Operation Manual

Setting
54
- ENGLISH
Settings
3D setting
This function is used to set the 3D display function.
Press ▲▼ to select these functions as
follows:
3D
J
Select among [Off], [On] and [NVIDIA 3D VISION]
mode.
* When selecting [NVIDIA 3D VISION] mode, the
other menus [3D sync], [3D->2D], [3D phase]
setting are not necessary. (displayed in gray)
3D sync
J
If you see a discrete or overlapping image, 3D
Sync Invert function* enables you to get the
correct image. Switch the 3D sync signal to
1
or
2
.
3D->2D
J
When viewing the 3D contents without wearing
the 3D glasses, set to "On" to convert 3D display
format to 2D display format.
3D phase
J
Adjust the phase of the 3D sync signal when the
3D SYNC OUT terminal is used. (0 - 31)
Note
The Frame Sequential Format is a technology that
z
rapidly alternates between left-eye and right-eye
images. When right-eye image and left-eye image
are switched or you feel like you cannot get 3D
effect due to out-of- synchronization state, first try
to synchronize the projector with the 3D glasses by
using 3D SYNC function.
Zoom
This function is used to memorize the Zoom
adjustment with the <ZOOM +/-> buttons on the
control panel.
Press ▲▼ to switch between each option
as below.
Reset
Reset the Zoom adjustment when the
projector is turned off or the AC power
cord is unplugged.
Store1
Store the Zoom setting even when the
projector is turned off. Zoom setting
is cleared when the AC power cord is
unplugged.
Store2
Store the Zoom setting even when the
AC power cord is unplugged.
Background
Select the background screen for when no input signal
is detected.
Press ▲▼ to select [Background].1 )
Press the <SELECT> button.2 )
Press ▲▼ to switch3 ) between each
option as below.
Blue
Blue colored background.
Black
Black colored background.
Display
This function decides whether to display O n-Screen
Displays.
Press ▲▼ to select [Display].1 )
Press the <SELECT> button.2 )
Press ▲▼ to switch3 ) between each
option as below.
On
Show all the On-Screen
displays *
1
Countdown
off
Show the input image instead
of the countdown when turning
on the projector *
2
Off
Hide the On-Screen Displays *
3
Use this function when you want to project *1 :
images after the lamp becomes bright enough.
The factory default setting is in this option.
Use this function when you want to project the *2 :
image as early as possible even when the lamp
is not bright enough.
Hide the On-Screen Displays except; *3 :
● On-Screen Menu.
● [Power off?]
● [P-timer] display.
● No signal for [Power management]
● [Please wait ...]
● Arrows for the True function in the Screen
Menu.