Operation Manual

NETWORK menu
ENGLISH -
101
Settings
E-mail setup page
J
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can
be sent to one or more preset e-mail addresses (maximum two addresses).
Click [Detailed set up], then [E-mail set up] to display the E-mail setup page.
Select “Enable” to use the E-mail function.
Enter the IP address or server name of the E-mail
server (SMTP). The DNS server must be set if
the server name is entered.
Enter the E-mail address of the projector.
(maximum 63 characters)
The user can enter the location of, for example,
the installed projector so that the recipient
may easily identify the originator of the E-mail.
(maximum 63 characters)
The user can modify the minimum time interval
of temperature warning mail. The default value
is 60 minutes. In this case, the user cannot
send another mail for 60 minutes after sending
previous temperature warning mail even the set
warning temperature is reached again.
Enter the E-mail address of your desired
recipient.
Select the conditions for sending E-mail.
MAIL CONTENTS: Select [NORMAL] or [SIMPLE].
ERROR: an error is detected by self-diagnosis.
LAMP1 RUNTIME: remaining lamp service time has reached the value set in the eld.
LAMP2 RUNTIME: remaining lamp service time has reached the value set in the eld.
FILTER REMAIN: remaining lter service time has reached the value set in the eld.
INPUT AIR TEMPERATURE: intake air temperature has reached the value set in the eld.