Operation Manual

Technical Information
ENGLISH -
119
Appendix
J
Cable specications
<When connected to a computer>
Projector
1 NC NC 1
Computer (DTE
specications)
2 2
3 3
4 NC NC 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
J
Control commands
When controlling the projector from a computer, the following commands are available:
<Projector control command>
Command Control contents Notes
PON Power [ON]
To see if the power is [ON], use the [Power query] command.
POF Power [OFF]
QPW Power query 000 = Standby 001 = Power [ON]
IIS Switch input modes
VID = VIDEO SVD = S-VIDEO RG1 = RGB1 RG2 = RGB2
DVI = DVI-D SDI = SDI (PT-DZ8700U/PT-DS8500U only) HD1 = HDMI
QSL
Query for active
lamp mode
0 = DUAL 1 = SINGLE 2 = LAMP1 3 = LAMP2
Û
[SINGLE] will use the lamp (LAMP1 or LAMP2) with shorter operating hours.
LPM Active lamp mode
0 = DUAL 1 = SINGLE 2 = Only LAMP1 is on 3 = Only LAMP2 is on
Û
[SINGLE] will use the lamp (LAMP1 or LAMP2) with shorter operating hours.
OLP Lamp power setting 0 = HIGH 1 = LOW
QLP
Query for lamp
output setting
0 = HIGH 1 = LOW
Q$L
Query for lamp
usage time
1 = LAMP1 2 = LAMP2
Response is 0000 - 3000
(Unit in hours: Number of equivalent hours for lamp output being set to [HIGH])
OSH Shutter 0 = End 1 = Execute
QSH
Query for shutter
state
0 = End 1 = Execute
VSE Switch aspect
0 = DEFAULT/VID AUTO/VID AUTO (PRI.) 1 = 4 : 3 2 = 16 : 9 5 = THROUGH
6 = HV FIT 9 = H FIT 10 = V FIT 20 = S1 AUTO 30 = VID AUTO
QSE
Query for aspect
setting
0 = DEFAULT/VID AUTO/VID AUTO (PRI.) 1 = 4 : 3 2 = 16 : 9 5 = THROUGH
6 = HV FIT 9 = H FIT 10 = V FIT 20 = S1 AUTO 30 = VID AUTO
OPP Execute P IN P 0 = OFF 1 = USER1 2 = USER2 3 = USER3
QPP
Query for P IN P
setting
0 = OFF 1 = USER1 2 = USER2 3 = USER3
QFI Query for lter 6 = Residual (ratio), Response is 000 - 100 (Unit: %)
OCS Switch sub memory 01 - 96 = Sub memory number
QSB
Query for sub
memory state
01 - 96 = Sub memory number
<Lens control command>
Command Sub command Contents Remarks
VXX LNSI2 Lens H shift
+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1
-
,
+00100 = Fine adjustment 2+, +00101 = Fine adjustment 2
-
,
+00200 = Rough adjustment +, +00201 = Rough adjustment
-
VXX LNSI3 Lens V shift
VXX LNSI4 Lens focus
VXX LNSI5 Lens zoom