Operation Manual

ENGLISH -
17
Preparation
About Your Projector
Attention
Do not drop the remote control.
z
Avoid contact with liquids or moisture.
z
Do not attempt to modify or disassemble the remote control.
z
Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as
z
uorescent.
Note
The remote control can be used within a distance of about 30 m if pointed directly at the remote control receiver. The
z
remote control can control at angles of up to ± 15 °C vertically and ± 30 °C horizontally, but the effective control range may
be reduced.
If there are any obstacles between the remote control and the remote control signal receptor, the remote control may not
z
operate correctly.
The signal will be reected off the screen. The operating range may differ due to the screen material.
When the projector receives a signal from the remote control, the Power indicator will ash.
z
Remote control
J
Top view
J
Front view
Installing/removing batteries
Press the tab and
lift up the cover.
Insert the batteries according to
the polarity diagram indicated
inside. (insert the
side rst).
Remove the batteries in the
reverse order to setting.
J
Bottom view
Remote control wired terminal
(
Æ
page 20)
Remote control signal emitters
Species the ID of the remote control.
(
Æ
page 20)
Restores the default factory setting.
(
Æ
page 49)
Assign the frequently use functions
from options for shortcut.
(
Æ
page 47)
These buttons are used together with
▲▼◄► to adjust focus, zoom and
shift by the projection lens.
(
Æ
pages 39, 41)
Switches the image aspect ratio.
(
Æ
page 48)
Pressing this button toggles the
projector’s internal mechanical shutter
to black out the projector.
(
Æ
page 46)
Pressing this button while projecting
an image automatically corrects the
picture positioning on the screen.
While the auto setup feature is active,
a message “PROGRESS” appears on
the screen. (
Æ
page 47)
Returns to the standby mode.
Makes the remote control available
to control any ID projectors.
(
Æ
page 20)
Displays projector information.
Enter ID number of the remote
control and adjustment values of
menu items.
Displays the test pattern.
(
Æ
page 47)
Displays and clears the on
screen indications.
(
Æ
page 46)
<MENU> button
Displays and clears the main menu, and
returns to the previous menu when the
menu is displayed.
Navigation and <ENTER> buttons
Navigate through the menu items with
▲▼◄►, and activate them with the
<ENTER> button. (
Æ
page 49)
These buttons select the RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and SDI terminals. (
Æ
page 46)
Starts the projection while in the
standby mode.
Remote control indicator
Flashes by pressing any
buttons.