User Manual

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 117
[COMMAND]
Detailed settings of
[COMMAND]
Description
[INPUT]
[VIDEO] Switches the input to VIDEO.
[RGB1] Switches the input to RGB1.
[RGB2] Switches the input to RGB2.
[DVI-D] Switches the input to DVI-D.
[HDMI] Switches the input to HDMI.
[SDI1]
*1
(PT-DZ13KE, PT-DS12KE)
Switches the input to SDI1.
(PT-DZ10KE)
Switches the input to SDI.
[SDI2]
*2
Switches the input to SDI2.
[LAMP SELECT]
[DUAL] Turns on two lamps.
[SINGLE]
Turns on one lamp. (The lamp with shorter runtime will
automatically light.)
[LAMP POWER]
[HIGH]
*3
Sets the lamp brightness to high luminance.
[MIDDLE]
*4
Sets the lamp brightness to slightly lower luminance compared to
[HIGH].
[NORMAL]
*5
Sets the lamp brightness to high luminance.
[ECO] Sets the lamp brightness to low luminance.
[P IN P]
[OFF] P IN P function is not used.
[USER1] Lays out the sub-screen with the settings of [USER1].
[USER2] Lays out the sub-screen with the settings of [USER2].
[USER3] Lays out the sub-screen with the settings of [USER3].
*1 Only for PT-DZ13KE, PT-DS12KE, PT-DZ10KE
*2 Only for PT-DZ13KE, PT-DS12KE
*3 Only for PT-DZ13KE, PT-DS12KE, PT-DW11KE. Even when the command for [HIGH] is set, it is not reected at the execution, if the optional
Replacement lamp unit (for portrait mode) (Model No.: ET-LAD320P (1 pc), ET-LAD320PW (2 pcs)) is used.
*4 Only for PT-DZ13KE, PT-DS12KE, PT-DW11KE
*5 Only for PT-DZ10KE
10) Press the <ENTER> button.
f The [COMMAND] detailed screen is displayed.
11) Press as to select a [COMMAND].
f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time you press qw.
12) Press the <ENTER> button.
f The command is xed and n is displayed at the left of the selected command.
f After the command is xed, press the <MENU> button to close the detailed setting screen.
13) Press asqw to select [STORE], and press the <ENTER> button.
Note
f If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen.
Set the time and command again.
f To delete a command already set, press the <DEFAULT> button on the Step 5) screen, or select [DELETE] on the Step 6) screen and press
the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. (x page 121)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with this function may not be executed.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST USED] Keeps the input selected last.
[VIDEO] Sets the input to VIDEO.
[RGB1] Sets the input to RGB1.