User Manual

Chapter 2 Getting Started — Setting up

ENGLISH - 31

Setting up

Installation mode

There are six ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 108) depending

on the installation location. Set [COOLING CONDITION] (x page 109) to [AUTO]. Using the projector with [COOLING CONDITION] set

incorrectly may shorten the life of the lamp.

Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear

(Using the translucent screen)

Menu item Method Menu item Method

[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]

[COOLING CONDITION] [CEILING SETTING] [COOLING CONDITION] [FLOOR SETTING]

Mounting on the ceiling and projecting from rear

(Using the translucent screen)

Setting on a desk/oor and projecting forward

Menu item Method Menu item Method

[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]

[COOLING CONDITION] [CEILING SETTING] [COOLING CONDITION] [FLOOR SETTING]

Portrait setting and projecting from the rear

(Using the translucent screen)

Portrait setting and projecting forward

Menu item Method Menu item Method

[PROJECTION METHOD] [REAR/FLOOR] [PROJECTION METHOD] [FRONT/FLOOR]

[COOLING CONDITION] [PORTRAIT SETTING]

*1 For the portrait setting, use the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD320P (1 pc), ET-LAD320PW (2 pcs)).

*2 Using the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD320P (1 pc), ET-LAD320PW (2 pcs)) will set the cooling condition

to [PORTRAIT SETTING].

Note

f In the portrait setting, the on-screen menu is displayed sideways.