User's Manual
Table Of Contents
- Read this first!
- Chapter 1 Preparation
- Chapter 2 Getting Started
- Chapter 3 Basic Operations
- Switching on/off the projector
- Projecting
- Operating with the remote control
- Using the shutter function
- Using the mute function
- Adjusting the volume
- Using the freeze function
- Using the on-screen display function
- Using the auto setup function
- Using the screen adjustment function
- Using the digital zoom function
- Switching the image aspect ratio
- Using the presentation timer function
- Using the FUNCTION button
- Displaying internal test pattern
- Using the status function
- Using the ECO management function
- Setting the ID number on the remote control
- Chapter 4 Settings
- Chapter 5 Operation of Function
- Chapter 6 Maintenance
- Chapter 7 Appendix
<SERIAL IN> terminal
The <SERIAL IN> terminal of the projector conforms with RS-232C so that the projector can be connected to and
controlled from a computer.
Connection
When connecting directly
When connecting with DIGITAL LINK compatible devices
D-Sub 9p (female)
D-Sub 9p (male)
Computer
Communication cable (straight)
LAN cable (straight)
D-Sub 9p (male)
Communication cable (straight)
Computer
(Not available for PT-VMZ40)
Projector connecting terminals
D-Sub 9p (female)
DIGITAL LINK
DIGITAL LINK
DIGITAL LINK compatible device
Projector connecting terminals
Note
f The destination of [RS-232C] (x page 87) must be set according to the connection method.
f When connecting by a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY
MODE] (x page 86) to [NORMAL] to control the projector in standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be controlled during standby.
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
Pin No. Signal name Details
(9)(6)
(5)(1)
(1)
― NC
(2)
TXD Transmitted data
(3)
RXD Received data
(4)
― NC
(5)
GND Earth
(6)
― NC
(7)
CTS
Connected internally
(8)
RTS
(9)
― NC
Communication conditions (Factory default)
Signal level
RS-232C-compliant
Sync. method
Asynchronous
Baud rate
9 600 bps
Parity
None
Character length
8 bits
Stop bit
1 bit
X parameter
None
S parameter
None
138 - ENGLISH
Chapter 7 Appendix - Technical information