Hints and Tips

Panasonic DLP Projectors(PTD7600/7500)
RS-232C Control Specifications
2003/03/27/2003
<CONTENTS>
1. Applicable models of Projectors ………………………………………… 1
2. Communication Format ……………………………………………………… 1
3. Command Format ……………………………………………………………… 2
4. Control by RS232C …………………………………………………………… 4
5. Commands
Control Command of R/C or key-pad …………………………………………… 5
Set-up Command of adjustment parameters …………………………………… 6
Status Monitoring Command ……………………………………………………… 10
1. Applicable Models
PTD7600U, PTD7500U
2. Communication Format
- Transfer Rate : 1200/2400/4800/9600/19200/38400/57600/
76800/102400/115200/153600/307200/
460800/921600 bps
- Parity Bit : Odd number / Even number / None
- Data Length : 8 bits
- Start, Stop Bit : 1 bit
- X, Y Parameter : None
- VPS SYSTEM : MASTER / SLAVE
* MASTER : Response to ID ALL command.
SLAVE : No response to ID ALL command
* Note for the system which use more than one unit
A. Set communication format same to the all, only one unit should be set as VPS SYSTEM
MASTER , the others should be set to VPS SYSTEM SLAVE.
B. Each projectors set to SLAVE should have own different ID.
C. When the projector’s main power is turned off, no output comes through RS-232C.
Turn on power of every projector to communicate Master and Slaves’ projectors.
* The Transfer Rate, Parity and VPS System can be set with RS-232C Setting in
Option menu.
* Projectors’ ID can be set with Option menu in each unit.
* Please use strait cable for communication between PC and Projectors.