Manual

Bold: VCR Function Italic: DVD Function
Bold ltalic: VCR and DVD Functions
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.85 W of
electrical power in off mode.
VHF/UHF Antenna Output Terminal
p.12
Component Video Output
Connector (Y, PB, PR)
(DVD Only)
p. 13
Optical Digital Audio--
Output Connector
(DVD Only)
p. 15
VHF/UHF Antenna Input Terminal
p. 12
VideoOutput Videolnput
Connector Connector
p. 12 p. 35
/
Audio Output 1
Connector (L/R)
p. 12
S-Video Out Connector Audio Output2 Audio Input
(DVD Only) Connector (L/R) Connector (L/R)
pp. 10, 13 p. 13 p. 35
The following table shows the status of the output jacks when in VCR or DVD mode.
Video Output Component S-VIDEO OUTAudio Out 1 Video Output
Audio Out 2
VCR YES N/A N/A
DVD YES YES
O• PROG functions on the remote are not available when using Component Video Output and
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
-To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2).When PROGRESSIVE OUT is set to "ON" in the DVD Main Menu (p. 55), a Progressive
Scan signal is output from the Component Video Output Connector.
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and
set PROGRESSIVE OUT to "OFF" in the DVD Main Menu. (See p. 55.)
10