Operating instructions

88
VHF/UHF
VHF/UHF
VHF/UHF
VHF/UHF
Initial Setup (Ready to Play)
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.
Please make all cable or antenna connections before power on.
Cable TV
Converter Box
Connecting
IN from
ANT./CABLE
UNIT (rear view)
UNIT (rear view)
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
Connections/Initial Setup (Ready to Play)
VHF/UHF
2 / 6 / 2003 THU 12 : 00 P M
DST : O N
A
UTO C L OCK SET
CO
M P L ETED
SETT I N G : CH 1 0
If AUTO
CLOCK SET IS
INCOMPLETE
screen appears,
set the clock using
MANUAL CLOCK
SET procedure on
next page.
A UTO C L OCK SET
IS INCO
M P L ETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
1
Plug the unit power cord into AC wall
outlet.
• If you use a cable
box, turn it on and
set it to the Public
Broadcasting Service
(PBS) channel in your
time zone. If you use
a DSS receiver, it
must be turned off.
Settings are made automatically. When
setup is done, this screen appears.
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : STOP
4
Press COMBO on the remote for Combo mode.
Press POWER on the remote or unit.
2
• Function buttons are inoperative during Initial
Setup.
• To remove a cassette during Auto Set, press
EJECT twice on the remote or STOP twice on
the unit. In this case, settings must be made
manually. (See page 10.)
• Depending on conditions, Auto Clock Set may
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
Notes
Auto channel and clock set starts.
3
Press CH to
select English.
OR
Press CH
to
select French
(Français).
OR
Press VOL+ to
select Spanish
(Español).