Operating Instructions - Language - English

17
Before Use
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
1
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
2
Re-attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come preattached
to the Grip Belt.
1 Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then pass
the Lens Cap through the loop made by itself
and pull tight.
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap
before going out to avoid dropping the Camcorder.
1 Pull the end of the Shoulder Strap through
the Shoulder Strap Holder on the Camcorder.
2 Fold the end of the Shoulder Strap, run it
through the Shoulder Strap Length Adjuster,
and pull it.
• Pull it out more than 1 inch (2 cm)
1
from the
Shoulder Strap Length Adjuster so that it cannot
slip off.
• Attach the other end of the Shoulder Strap to the
other Shoulder Strap Holder in the same way.
Inserting a Cassette
1 Slide the [OPEN/EJECT] Lever
37
toward the
front and pull down to fully open the Cassette
Compartment Cover.
• To protect the tape, if the cover is not fully opened,
the cassette cannot be ejected.
2 Insert a Cassette.
3 Close the Cassette Holder by pressing the
[PUSH] mark
1
.
4 Close the Cassette Compartment Cover by
pressing the mark
2
.
The Grip Belt
To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your
hand.
1 Detach the end of the Grip Belt.
2 Adjust the length of the Grip Belt to the size
of your hand.
3 Reattach the Grip Belt.
1
37
2
1
1
2
• When you remove the Lens Cap, press the knobs
fi rmly.