Operating Instructions

- 12 -
Listening to FM radio
You can preset up to 30 FM channels.
Channel 1 to 5 will be set under [1] to [5] on this unit.
(l right, “Changing the stations stored under [1] to [5]”)
Preparation
≥ Extend the antenna. (l 5)
≥ Turn the unit on.
≥ Press [O, N SELECT] (this unit: [DAB/FM]) repeatedly
to select “FM”.
1 Press [PLAY MENU] to select “A.PRESET”.
2 Press [3, 4] to select “LOWEST” or “CURRENT”
and then press [OK].
LOWEST:
To begin auto preset with the lowest frequency
(“FM 87.50”).
CURRENT:
To begin auto preset with the current frequency.
§
≥ The tuner starts to preset all the stations it can receive into
the channels in ascending order.
≥ To cancel, press [∫].
§: To change the frequency, refer to “Manual tuning”.
1 Press [PLAY MENU] repeatedly to select “TUNE
MODE”.
2 Press [3, 4] to select “PRESET” and then press
[OK].
3 Press [:/6] or [5/9] to select the channel.
≥ You can select channel 1 to 5 by pressing one of [1] to [5] on this
unit.
∫ Manual tuning
1 Press [PLAY MENU] repeatedly to select “TUNE
MODE”.
2 Press [3, 4] to select “MANUAL” and then press
[OK].
3 Press [:/6] or [5/9] to tune in to the
station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
1 While listening to the radio broadcast
Press [OK].
2 Press [3, 4] to select the channel and then press
[OK].
≥ Do steps 1 through 2 again to preset more stations.

≥ A station previously stored is overwritten when another station is
stored in the same channel preset.
(On this unit)
You can change the stations stored under [1] to [5] easily.
While listening to the radio broadcast
Press and hold one of [1] to [5] until “P ” appears on the
display.
(“  ” stands for a number.)

≥ When you change the stations stored under [1] to [5], channel 1
to 5 are also changed to the same corresponding stations.
∫ To display the current FM signal status
[D552] Press [DISPLAY] repeatedly to select “FM STATUS”.
[D550] Press [DISPLAY].

≥ “STEREO” is displayed when this unit tunes to a stereo
broadcast.
∫ [D552] To display Radio Data System text
data
This system can show the text data transmitted by the
Radio Data System available in some areas.
Press [DISPLAY] repeatedly.

≥ Radio Data System is available only when stereo works in
reception.
≥ Radio Data System may not be available if reception is poor.
Presetting stations automatically
Listening to a preset channel
Presetting stations manually
Changing the stations stored under [1]
to [5]
“FM ST”: FM stereo broadcast is being received.
“FM - - - -”: No broadcast is received or FM broadcast
received is weak or in monaural.
“FM MONO”: You have set the “FM MODE” to “MONO”.
(l 16, “If noise is excessive during FM
reception.”)
“PS”: Programme service
“PTY”: Programme type
“FREQ”: Frequency