Operating Instructions

- 6 -
Power sources
Connect the AC mains lead firmly to the unit and the
household mains socket.

≥ Do not use any other AC mains lead except the supplied one.
This unit will use the batteries as the power source when
you disconnect the AC mains lead.
Use alkaline or manganese batteries.
Install the batteries so that the poles (r and s) align with
those in the unit.
≥ When using batteries as the power source:
– the volume is comparatively lower.
– this unit cannot be turned on from the remote control.
Battery indicator
When the batteries are weak, “ ” light up on the
display.
≥ When “ ” flashes, replace all the batteries with new ones.
≥ While the unit is on, do not switch the power source from AC to
battery power, or vice versa. Press [Í/I] to switch the unit to
standby mode before switching power sources.
Battery removal
Do not pull the battery out from the end placed against the
spring. Remove the battery by lifting its positive end (r).
Using the remote control
Insert the battery so the terminals (i and j) match those
in the remote control.
Point it at the remote control signal sensor on this unit.
≥ To avoid interference, please do not put any objects in front of
signal sensor.
DEMO play
This unit is built-in with a sound demonstration music.
To play the demonstration music
1 Turn the unit on.
2 Press and hold [SOUND BOOSTER, −DEMO] on this
unit for at least 2 seconds until “WAIT FOR DEMO
PLAY” appears on the display.
The demonstration music will be played for approximately
1 minute. (“DEMOPLAY” is displayed during DEMO play.)
After playback completes, this unit will automatically exit
the DEMO play mode.
≥ To exit during DEMO play, press [∫].
Using the household mains socket
Using the batteries (not supplied)
Disconnect the AC mains lead from the unit to
operate on battery power.
AC mains lead (supplied)
To household mains
socket
R14/LR14, C
(Alkaline or manganese
battery)