Manual

Speaker settings
Adjusting the sound lag between speakers
Delay time ([])
For optimum listening with 7.1-channel sound, all the speakers, except
for the subwoofer, should be the same distance from the seating
position•
If you have to place the center, surround and surround back speakers
closer to the seating position, adjust the delay time to make up for the
difference•
If either distance @ or (_ is less than © (=> below), find the difference
in the relevant table and change to the recommended setting•
O Press [A, V, 4, I_] to select the distance box ([]) and press
[OK].
O Press [A, V] to select the setting and press [OK].
Approximate room dimensions
:Actual speaker position
Center (C)
I
[LS (L)] Surround [RS (R)]
i
[LB (L)] Surround back [RB (R)]
• ideal speaker position
@(_© : Primary listening distance
Circle of constant primary listening distance
@ Center speaker
im]1ii',.rt,.fit",_ [,.-.t_iai_j
Approx• 34 cm (1 ft. 1 in.) 1.0 ms
Approx• 68 cm (2 ft. 2 in.) 2.0 ms
Approx• 102 cm (3 ft. 4 in.) 3.0 ms
Approx• 136 cm (4 ft. 5 in.) 4.0 ms
Approx• 170 cm (5 ft. 6 in.) 5.0 ms
Surround/Surround back speakers
im]1ii',.rt,.fit",_ [,.-.t_iai_j
Approx• 170 cm (5 ft. 6 in.) 5.0 ms
Approx• 340 cm (11 ft. 1 in.) 10.0 ms
Approx• 510 cm (16 ft. 8 in.) 15.0 ms
Volume (Channel balance) (_)
(Effective when playing multi-channel audio)
O Select "Test" and press [OK].
A test signal is output.
Front (L) ---_>Center _Front (R) -_> Surround (RS)
t
Surround (LS)<-_ Surround back (LB) <-_ Surround back (RB)
O While listening to the test signal, press [A, V] to adjust the volume
of each speaker.
The volume can be adjusted between -I-6 dB to -6 dB.
oSet each speaker level according to the volume of the Front (L)
and Front (R) speaker volume respectively.
I_ Press [OK].
The test signal stops.
oNo signal is output for the subwoofer. To adjust its volume, see
page 18, Adjusting speaker level during play.
i
[LB (L)] Surround back
Center (C)
Surround
[RS (R)]
Surround back [RB (R)]
• To finish the speaker setting
Press [A, V, 4, I_] to select "Complete" and press [OK].
RQT9371