Operation Manual

ENGLISH
ENGLISH
RQT9679
5
5
iPod/iPhone, Disc, USB
Inserting or removing media
iPod/iPhone
Push [iPod x] to open the dock tray.
Note:
Make sure to remove the iPod/iPhone from its case.
Make sure to align your iPod/iPhone with the connector
when inserting.
Use a compatible dock adapter.
If a dock adapter is not available, insert and remove the
iPod/iPhone with care.
Disc
Press [CD x OPEN/CLOSE] on the main unit to open the
sliding door.
Put in a disc with the label facing towards you.
Note:
Keep fingers away from the sliding door when it is closing.
USB
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
iPod/iPhone
(not supplied)
Dock adapter
(not supplied)
Connector
Click!
USB device
(not supplied)
Getting started
1 Connect the FM indoor antenna.
Place the antenna where reception is best.
2 Connect the AC mains lead.
Power consumption in standby mode: 0.2 W
(approximate)
Do not use an AC mains lead from other equipment.
Note:
Some settings return to default when you disconnect the
system.
These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
You cannot remove the net of the speakers.
Preparing the remote control
Before using
Replacing the battery
Replace with a new battery (CR2025 lithium battery).
1 While pressing the stopper, pull out the battery
holder.
2 Insert a new battery with the (+) side facing up.
3 Push the battery holder back fully.
Tape
To household mains socket
Insulation sheet
CR2025
HC27_EC1_1en.indd 5HC27_EC1_1en.indd 5 5/14/2012 4:13:30 PM5/14/2012 4:13:30 PM