User Manual

28
TQBM0483
“USB OVER CURRENT ERROR”
The USB device is drawing too much power.
≥ Disconnect the USB device. After that, turn off
the main unit and then switch it on again.
≥ Turn the main unit off and then on again.
“LOAD FAIL”
The firmware loading has failed. Check to see if
the correct firmware is stored on the USB device.
“LINKING”
≥ This system is trying to connect to the last
connected Bluetooth
®
device when
“BLUETOOTH” is selected.
“REMOTE ” (“  ” stands for a number.)
The remote control and this system are using
different codes. Change the code on the remote
control. (> 17)
SC-HTB700-EGEBGNGW-TQBM0483_eng.book 28 ページ ２０１９年６月６日 木曜日 午前１０時２１分