User Guide
RQTX0072
7
Simple setup
■
Do not:
mix old and new batteries.
use different types at the same time.
heat or expose to flame.
take apart or short circuit.
attempt to recharge alkaline or manganese batteries.
use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which
can severely damage the remote control.
Remove the batteries if the remote control is not going to be
used for a long period of time. Store in a cool, dark place.
■
Use
Aim at the remote control sensor (
➡
page 14, Operations
Guide), avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
•
•
•
•
•
•
Remote control
Insert so the poles (+ and – )
match those in the remote control.
Do not use rechargeable type
batteries.
•
•
R6/LR6, AA
Press on the
tab to open
Insert this
side first when
closing
Batteries
The remote control
STEP
Other television connections
S VIDEO
OU
T
V
IDE
O
O
U
T
COMPONENT
VIDEO OUT
Y
P
B
P
R
R
E
C
OUT
AUX
R L
A
M
A
A
A
N
A
A
T
EXT
L
O
LL
O
O
O
P
F
M
A
N
T
(
75
Ω
)
+
AV
AV OUT
The S VIDEO terminal achieves a more vivid picture than the VIDEO OUT
terminal by separating the chrominance (C) and luminance (Y) signals. (Actual
results depend on the television.)
Back of this unit
S VIDEO
OU
T
S-VIDEO
IN
Television
S Video cable
(not included)
■
Using an S VIDEO OUT terminal
The COMPONENT VIDEO OUT terminals can be used for either interlace
or progressive output and provide a purer picture than the S VIDEO OUT
terminal. Connection using these terminals outputs the colour difference signals
(P
B
/P
R
) and luminance signal (Y) separately in order to achieve high fidelity in
reproducing colours.
The description of the component video input terminals depends on the
television or monitor (e.g. Y/P
B
/P
R
,Y/B- Y/R-Y, Y/C
B
/C
R
). Connect to terminals of
the same colour.
•
To enjoy progressive video
Connect to a progressive output compatible television.
1. Set “Video Mode” to “Off” (
➡
“HDMI” tab, page 29, Operations Guide)
2. Set “Video Output Mode” to “480p” or “576p”, and then follow the instructions
on the menu screen (
➡
Picture Menu, page 24, Operations Guide).
•
Television
VIDEO OUT
COMPONENT
VIDEO OUT
Y
P
B
P
R
COMPONENT
VIDEO IN
PR
PB
Y
Back of this unitVideo cable
(not included)
■
Using a COMPONENT VIDEO OUT terminal
Step 3: Television, antenna and AC mains lead connections /
Step 4: The remote control
NC9_ 6 EB Setup.indd 7 2/26/2007 3:02:27 PM