Operating Instructions
42
VQT3Z99
Speaker installation option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
You can attach all of the speakers (except
subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 kg per screw.
1 Drive a screw (not supplied) into the wall.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.0 mm to
‰ 9.4 mm
D Wall or pillar
E 5.5mm to 7.5mm
2 Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below to identify
the screwing positions on the wall.
≥ Leave at least 20 mm of space above the
speaker and 10 mm on each side to allow
enough space for fitting the speaker.
[BTT282]
Front speaker
Attach to a wall without the stand. (> 13)
A 37 mm
B 45 mm
[BTT182]
Front speaker
C 40 mm
D 24 mm
Preventing from falling
[BTT282] Front speaker
Preventing from dropping
Front speaker
1 Thread a string to the speaker.
≥ Use a string of less than ‰ 2.0 mm, which is
capable of supporting over 10 kg.
e.g., [BTT282] Front speaker
A String (not supplied)
B Rear of the speaker
2 Thread a string from the wall to the
speaker and tie tightly.
C Screw eye (not supplied)
D Wall
E Approx.150 mm
F Less than 100 mm
Attaching to a wall
e.g., [BT T 282] Front speaker
DO NOT DO
≥ In this position, the
speaker will likely fall if
moved to the left or right.
≥ Move the speaker so
that the screw is in this
position.
Preventing the speakers from
falling or dropping
When mounted on a wall
When placed on the floor
SC-BTT282&182EB-VQTVQT3Z99_mst.book 42 ページ 2012年2月8日 水曜日 午前11時8分