Operating Instructions
Getting started
13
VQT3M06
[BTT370]
1
Use of the speaker cable stickers is
convenient when making cable connections.
e.g. Front speaker (L)
A Speaker cable sticker (supplied)
B Connector
Be sure to match the number on each sticker with the connector colour.
2 Connecting the speaker cables. Insert the
wire fully, taking care not to insert beyond
the wire insulation.
e.g. Surround speaker [BTT270]
≥ Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
≥
Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable.
≥ To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.
≥ Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.
[BTT775] [BTT770] [BTT370]
∫ Preventing the speakers from falling
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of supporting over 10 kg.
e.g. [BTT775]
A String (not supplied)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not supplied)
D Wall
E Approx.150 mm
Preparing cables and making connection
Thread the speaker cable through the base.
≥ Use cables with a white connector and red connector.
Leave about
110 mm
Insert the wire fully.
r: White
s: Blue line
Pull the cable
straight along the
line and slide into
the groove.
Tighten securely.
Press into the groove.
Push!
Back of the base
Speaker cable sticker Colour
1 FRONT (L) WHITE
2 FRONT (R) RED
3 SURROUND (L) BLUE
4 SURROUND (R) GREY
5 CENTRE GREEN
6 SUBWOOFER PURPLE
FRONT
Lch
Push!
r: White
s: Blue line
SCBTT775_770_370_270EBEPGN_VQT3M06.book 13 ページ 2011年1月18日 火曜日 午後6時14分