Operating Instructions

TQBJ2196

Placing the main unit in a rack or on a table

Additionally required accessories (commercially available)

 Fall prevention cord (x2)

 Screw eyes (to attach the fall prevention cord) (x2)

Note:

• Use commercially available screws that are capable of supporting over 24 kg.

• Use a cord that is capable of supporting over 24 kg (with a diameter of about 1.5 mm).

1 Attach the cord to the main unit.

If the cord cannot be threaded through the holes, try bending the cord, about 5 mm apart from the tip,

at an angle of 45° (as illustrated above).

2 Place the main unit in the desired position and attach each cord onto the

rack or table.

Make sure that the slack of the cord is minimal.

Do not lean the main unit against the TV or wall.

Attach the screw eye at a position capable of supporting over 24 kg.

Depending on the placement of the main unit, the screwing position of the screw eye may differ.

Cord

Screw eye

TQBJ2196_en.fm Page 12 Tuesday, February 26, 2019 6:32 PM