Operating Instructions

26
TQBM0479
∫ Automatic input switching
When the following operations are performed, the
main unit will automatically change the input to
the corresponding source.
jWhen play starts on an HDMI connected
device.*
3
jWhen the TV input or the TV channel is
changed.
*3 If the speaker output setting on the TV is set to this
system, the TV and the main unit turn on automatically
(Power on link).
∫ Power off link
When the TV is turned off, the main unit also turns
off automatically.
(This function does not work when
“BLUETOOTH” or “NETWORK” is the source.)
∫ Automatic lip-sync function
(for HDAVI Control 3 or later)
Delay between audio and video is automatically
adjusted by adding time-lag to the audio output,
enabling you to enjoy smooth audio for the
picture.

≥ It may take up to 8 seconds for sound to be output from this
unit after turning the TV (VIERA) on. You can reduce the
amount of time it takes for sound to be output by using an
optical digital audio cable. If you do so, reconnect the
HDMI cable to a non-ARC compatible HDMI terminal on
the TV (VIERA). (> 8)
≥ The delay information is automatically set if the TV is
compatible to VIERA Link “HDAVI Control 3” or later and
the VIERA Link is set to on.
The setting causes a sound delay of approximately 0.04
seconds when connected to a Panasonic TV (VIERA) with
VIERA Link (HDMI) version 2 or earlier or a TV from
another manufacturer.
Reference
Troubleshooting
Before requesting service, make the following
checks. If you are in doubt about some of the
check points, or if the solutions indicated in the
following guide do not solve the problem, consult
your dealer for instructions.
The unit does not work.
Operations are not done properly.
1 Touch [Í/I] on the main unit to turn it off.
≥ If the main unit still does not turn off, touch and hold
[Í/I] on the main unit for at least 5 sec. This will force
turn off the main unit. Alternatively, disconnect the AC
mains lead, wait for at least 3 minutes, then reconnect
it.
2 Touch [Í/I] on the main unit to turn it on.
(It may take some time for the main unit to be
turned on.)
Consult your dealer if the problem persists.
No power.
≥ Unplug the AC mains lead for at least 3 minutes
before plug in again.
≥ After turning the main unit on, if the main unit
immediately turns off, unplug the AC mains lead
and consult your dealer.
≥ If the main unit does not turn on by turning on
TV (HDAVI Control), turn on the main unit
manually.
If the problem persists, refer to “HDMI” in
“Troubleshooting”.
If this system does not operate as
expected, returning the settings to the
factory preset may solve the problem.
To return to the factory preset.
1 Press [SETUP] repeatedly to select
“RESET” and then press [OK].
≥ You can also press [4] or [3] repeatedly to select
the setup item.
2 Press [4][3] to select “OK?YES” and
then press [OK].
≥ “RESET” blinks on the display. After the “RESET”
display goes out, “TV” is selected as the source for
this system.
≥ The remote control code will return to
“REMOTE 1” when this system is returned to
the factory preset. To change the remote
control code, refer to “Remote control code”
(> 18).
General operation
SC-HTB900-EGEBGN-TQBM0479_eng.book 26 ページ ２０１９年１０月１５日 火曜日 午後３時１２分