Operating Instructions
Table Of Contents
- Safety precautions
- Caution for AC mains lead
- Sales and Support Information
- Supplied accessories
- Placement of speakers
- Preparing the remote control
- Making the connections
- Overview of controls
- Preparing media
- Media playback
- FM Radio
- DAB+
- Sound effects
- Clock and timers
- Others
- Troubleshooting
- Maintenance
- Specifications
- References
22
TQBM0933
D:\A_Job\PSG\_FY22\SC-PM270\Source\woi\PM272EB.EG_TQBM0933_EN.fm
Clock and timers
Setting the clock
This is a 24-hour clock.
1 Press [SETUP] repeatedly to select “CLOCK”.
2 Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select “CLOCK” and then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to wake you up.
Preparation
Set the clock.
1 Press [SETUP] repeatedly to select “TIMER ADJ”.
2 Press [R, T] to set the start time and then press [OK].
3 Do step 2 again to set the end time.
4 Press [R, T] to select the source you want to play and then press [OK].
To start the timer
1 Prepare the source you want to listen to (disc, USB or radio) and set the volume.
2 Press [SETUP] repeatedly to select “TIMER SET”.
3 Press [R, T] to select “SET” and then press [OK].
“#” is shown.
To cancel, select “OFF”.
The system must be switched off for the timer to operate.
To check the setting
Press [SETUP] repeatedly to select “TIMER ADJ” and then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to the preset level.
• The timer comes on at the set time every day if the timer is on.
• If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the
end time.
PM272EB.EG_TQBM0933_EN.fm Page 22 Wednesday, August 30, 2023 4:20 PM