Operating Instructions

9
TQBM0933
D:\A_Job\PSG\_FY22\SC-PM270\Source\woi\PM272EB.EG_TQBM0933_EN.fm
[PM270]
Connect the FM indoor antenna.
Put the antenna where reception is best.
2 Connect the speakers.
Connect the speaker cables to the corresponding terminals.
3 Connect the AC mains lead.
Do not use any other AC mains leads except the supplied one.
Conserving power
The system consumes a small amount of power even when it is in standby mode. Disconnect the
power supply if you do not use the system.
Some settings will be lost after you disconnect the system. You have to set them again.
Note:
Keep the antennas away from the speaker cables and the AC mains lead to avoid picking up noise.
Be careful not to cross (short-circuit)
or reverse the polarity of the speaker
wires as doing so may damage the
speakers.
(For the AC mains plug of three pins)
READ THE “Caution for AC mains lead” BEFORE CONNECTION. (~4)
Attaching the ferrite core near to the
terminal
A Pull on the tabs (both sides) to open.
B Put the AC mains lead onto one of the
concave surfaces.
C Coil the AC mains lead around the ferrite
core and onto the other concave
surface.
D Close the ferrite core until it clicks.
Note:
Failure to attach the ferrite core to the AC
mains lead may cause interference to other
devices nearby.
Adhesive tape
(not supplied)
(6:)
(6:)
B
A
Red
Black
(6:)
(6:)
To household
mains socket
5 cm
PM272EB.EG_TQBM0933_EN.fm Page 9 Wednesday, August 30, 2023 4:20 PM