Operating Instructions

14
TQBJ2186
14
3 Press [R, T] to select “PLAY ON” and then press
[OK].
To cancel, select “PLAY OFF”.
The system must be switched off for the timer to
operate.
To check the setting
1 Press [SETUP] repeatedly to select “TIMER ADJ”.
2 Press [R, T] to select “#PLAY” and then press
[OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to
the preset level.
• The timer comes on at the set time every day if the timer is
on.
• If you switch off the system and then switch on again while a
timer is in operation, the timer will not stop at the end time.
External equipment
Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Note:
• Do not bend cables at sharp angles.
• Components and cables are sold separately.
• Sound distortion can occur when you use an adapter.
• If you want to connect equipment other than those
described, refer to the audio dealer.
Using the optical input
You can connect a TV, VCR, DVD player etc., and listen to
the audio through this system.
1 Connect the external equipment.
2 Press [SELECT <, >] repeatedly to select “D-IN”.
3 Play the external equipment.
Note:
• This system supports linear PCM signal.
• Multi-channel source will be converged to 2 channels.
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz, up to 96 kHz
• The sound is muted if the signal format or frequency is not
supported.
• If there are sounds coming from the TV’s speakers,
decrease the volume of the TV to its minimum.
Using the auxiliary input
You can connect a VCR, DVD player etc., and listen to the
audio through this system.
1 Connect the external equipment.
2 Press [SELECT <, >] repeatedly to select “AUX”.
3 Play the external equipment.
Rear panel
of this unit
Optical digital
audio cable
(not supplied)
TV (not supplied)
Rear panel
of this unit
Audio cable
(not supplied)
DVD player (not supplied)
SC-TMAX10E_TQBJ2186 (01) En.fm Page 14 Wednesday, June 1, 2022 1:26 PM